I connected to the Dreambox via http and flashed this, and now the box shows No CA found, What to do now?
Flashed bootloader and now the box shows No CA found
-
- Image Flashing Support
- tru01
- Thread is marked as Resolved.
-
-
More info needed as to why this has happened.. Do you definitely have a V2 dm800se sim 2.2 ? Which image was previously installed or which were you trying to install ? Did you flash image first then the bootloader immediately after ?
-
Just unpacked this box from the package, brand new DM800HDSEV2 original from trusted supplier.
Wanted to install Enigma2 so I downloaded the latest version 4.0.11.
Connected the box via http, box shows: DM800SEv2 second stage loader #88 (2013-05-01)
and tried to flash with the newnigma2_stable_dm800_v4.0.11.nfi
Got failure WRONG ARCHITECTURE errorRead on the forum that I needed a second stage loader so i flashed with SSL88A_seV2.nfi
Now box shows No CA foundDownloaded Dreamup133_11 and release-dm800sev2-4.0.0.nfi
Box is now showing completed uploading file to box
next message is: box is flashing from its memory and have been doing this for 1 hourReally appreciate your quick response!
-
Quote
newnigma2_stable_dm800_v4.0.11.nfi
Be careful which image you flash on to your receiver buddy.. You flashed an image for DM800 on a DM800SE V2, that`s why you got no ca error.. Only use images for DM800SE V2.
QuoteDM800SEv2 second stage loader #88 (2013-05-01)
Your receiver already has the latest bootloader, so no need to flash it again..
Put the receiver into flash mode and flash this image via a browser window ==> OpenATV
http://images.mynonpublic.com/….1-dm800sev2-20140616.zip
-
Flashing box via browser window is no longer working, display only shows R01:no ca found,
no stop message or IP address.
Can I use Dreamup for this?, it is connecting to the box -
You could use dreamup, but it takes ages to flash. Try this tool instead ==> Dreambox OptiFlasher Enigma2 EDition Latest Version
-
turn box off the there is a small button on back hold this in while turning box on , then reflash with a suitable image via web browser
-
This same issue i was having.....have you tried dreamup sunray? and make sure you flash your firmware first
-
Thank you all for the good tips!
Turned out that I had several issues to deal with. Using win7 64bit and having the Dreamup stored on a shared HD was not a good idea.
The Dreamup was not working correctly. When copying the original image and Dreamup to my desktop it finally worked.
I restored the original image and then used the web interface to flash OpenATV.After recovering from this nerve wrecking event :-)
What is in your opinion the best image for DM800HD se V2 ? -
i personally use tsimage
-
Thanks for the tip D, I will give tsimage a try, as I experience bad sync with video and sound in some of the channels with Openatv
-
hi, have try OPEN PLI image ?
-
no open pli for dm800se v2 i have found
-
Try this link buddy: http://linuxsat-support.com/view.php?pg=openpli
-
cant see dm800se v2 the v2 being the stumbling block
-
master G
Added the Label Image Flashing & Backup Support
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!