cccam support needed

There are 7 replies in this Thread which was already clicked 2,116 times. The last Post () by mckee25.

    Hi to all


    I am trying to configure my vu+ solo with cccam. I am new to this and I need support.
    1.- i upgraded the vu with latest BH image 2.1.1............installation seems Ok
    2.- i downloaded CCcam-2.3.0 as .ipk and installed it ......installation seemed to be running well without errors.
    first question...... how can i confirm that it was installed properly and is functioning well.
    3.- i copied the cccam.cfg from the thread in this forum modified it and saved it into /var/etc
    i am suspecting that is not configured properly
    4.-i installed these files found in another thread CCcam.channelinfo ,,, CCcam.providers,, CCcam.prio,, into var/etc
    are these 3 files enough???? do i have to install other extra files???


    Any help will be appreciated.

    you can check CCcam status through system menu _ SOFTCAM manager !
    ensure it is running and set to Enable on start up .

    78cm dish on tm2300 metal gear motor + 1m Orb with tm2300 + 1.8m Channel Master on H-H floor mount + 80cm ISS with TM2300 AND Inverto Black LNB,inverto Unicable QUDL 42 LNB,- Global invacom Dscc LNB,- Triax KA LNB, - Yuri LNBF C Band YLF-CDP16C

    • Official Post
    Quote

    first question...... how can i confirm that it was installed properly and is functioning well.


    Make sure you are using CCcam from here => BlackHole 2.X.X Softcam Collection


    Connect to CCcamInfo in your browser http://ip.address.of.solo:16001 If you don`t see this web interface CCcam is not running..


    Use the attached CCcam.cfg > FTP it to /etc folder..


    CCcam.channelinfo ,,, CCcam.providers,, CCcam.prio,, are not really necessary.. They populate provider and channel information in CCcamInfo, also prioritize certain providers..

    first thankyou


    when I enter Ip my adress 192.168.1.10 the open webif page loads and works
    in case of 192.168.1.10:16001 the page does not load


    Is it a port forward problem???

    • Official Post

    You don`t need open ports for internal access, a port would need opened if you are trying to connect from outside your own network..


    If 192.168.1.10:16001 doesn`t load, try a different browser like firefox or chrome.. If that still doesn`t work CCcam is not running.. Press Blue button > scroll left or right to select CCcam as default softcam > Press Ok to start..

    sometimes its true when someone says that problem is solved with a click of a button!
    the problem was that the cccam was not set as default so it was never initiated.
    in fact with the blue button i set it correctly and then i was :57:



    also 192.168.1.10:16001 worked fine and now i am understanding a little bit more whats going on!



    guys thank u for your help

Your resource for CCcam softcam

Find downloads, configuration files, setup tutorials, and community support for card sharing and server management. Master CCcam configuration and card sharing. Access dedicated support, step-by-step tutorials, config files, and downloads for your Enigma2 setup.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login