Hi can anybody help with my problem I recently brought a Moteck motor usals I connected it up to my dm500s it will move when I press east and west buttons but will not move more than one step on each press of the button I then tried my friends dm800 exactly the same problem I then changed the cable and still no luck I then reset motor in case that was the problem nothing changed
Can anybody help cheers
:waaaht:
it should only move step by step,,, another thing is if you setup usals from 0º then it will move freely from memorised sat to sat..
ok Thanks i will try that.:83:
well set the motor to 0 deg then input lat long into the dm800 still the motor will not move more than one step also noticed that it will not drive when a v-transponder is selected only a Horizontal i think its the motor i might have to take a look inside it
if its new return it.. but beforehand make sure that the box has all the correct settings.. motor setup,etc,,
Don’t have an account yet? Register yourself now and be a part of our community!
