Dm800HD PVR MultiFeed LNB Tune Failed

There are 8 replies in this Thread which was already clicked 4,683 times. The last Post () by foz.

    Hi to all,


    Please, I need your help regarding an issue with my DM800. Lately it is shown the famous message "tune failed" in many channels on different satellites. I changed the three LNBs that I was using so far, but after several days it's the same situation. I tested with 2 other Dm800 boxes and it was the same problem, but another DM500 is working fine with the same LNBs. My DM800 is working fine in another location. I even tried the command "echo # > /proc/stb/frontend/0/tone_amplitude" - this value fixes the Diseqc-problem with se veral values, but no results, the same situation.


    Any idea what to check next?


    Thanks in advacne for your help
    Finally

    Hi


    I get that message aswell sometimes on my Dm800 when i change channel or satellite but normally i just change to another channel then go back and its ok...Is there any season why this happens?


    I'm using an openpli image 2.01 82.....


    Thanks

    Hi to all,


    Thanks to all for your replies.


    The problem is that, I don't face such problem if I connect DM500, or any other receiver. It's just with Dm800. I re-flashed as well, but it's the same.


    very strange situation...



    Thanks,
    Finally

  • master G

    Added the Label MultiFeed LNB Config

  • master G

    Changed the title of the thread from “Dm800 Tune Failed” to “Dm800HD PVR MultiFeed LNB Tune Failed”.

Your resource for Enigma2 tuner configuration

Find tutorials and support for setting up DVB, advanced FBC, and USB tuners for satellite, cable, and other signal sources. Master your receiver's tuning capabilities. Find dedicated support and guides to configure DVB, FBC, and USB tuners for optimal satellite, cable, and digital TV reception.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login