How do you tell the openbox m3 to use ccam rather than the CI?
how to set open box to use ccam
- Banny
- Thread is marked as Resolved.
There are 10 replies in this Thread which was already clicked 1,989 times. The last Post () by Antepenultim8.
-
-
ok its just dawned on me i may need to install this, which version do i install and where do i get it from?
-
please start using the searchbar ,you´ll be amazed that it works!!!! http://linuxsat-support.com/op…usb-my-openbox-s9-hd.html
-
im using the m3 version and it did find ccam.cfg on usb drive
-
If you read all the posts you will see other links to help/possibly guide you..
-
im using the m3 version and it did find ccam.cfg on usb drive
Please check the correct name , maybe CCcam.cfg
-
The filename is correct other than adding CCam.cfg details to the box, is there anything else that is needed so that it will start to use this ccam to clear scrambled channels?
-
its CCcam.cfg
-
well i added the info manually, but how do i get it to use that info?
-
usually just a reboot starts it off, make sure details are saved
-
-
manage cccam cfg
tick
c-line
as explained in Openbox tutorials
http://linuxsat-support.com/op…cline-data.html#post47065
Firmware, downloads and support for Openbox / Skybox.
Your community resource for the Openbox / Skybox satellite receiver — firmware images, channel lists, plugins and setup help.
