Thanks to dreaoem toolbox I was able to revive mh DB dm800. After several attempts ans a lot of patience I manged to. Repai CA tool plus load image. I had to switch on and off severa time but I think worked only when I tried to switching on leeping on-off butto for a while after powering on, with stead dreambox logo on, after that I was able to operate dreamoptiflasher pro in advanced mode, IP and Serial, good job , I ma now going to setup, next challenge is activate TVSAT on scam 3.58 enjoy and thanks to you all
No CA Found
- el tel
- Thread is marked as Resolved.
There are 28 replies in this Thread which was already clicked 5,269 times. The last Post () by gemini man.
-
-
fy84tz Thanks for your imput ,perhaps you could pass by introductions now so we get to know each other ;)
-
I have same problem, no ca found in clone box.
After using optiflsher, I get dm800 detected . Wrong boot response.
Any one knows how fix it? -
Use DreamUp 1.3.3 with serial (null modem) cable and flash your box with the correct image.
-
Use DreamUp 1.3.3 with serial (null modem) cable and flash your box with the correct image.
does not work
-
Open the receiver and check the SIM
Put it off and on so you can be sure that it is in the correct position. -
Open the receiver and check the SIM
Put it off and on so you can be sure that it is in the correct position.
hello stranger ,
can you please pass by introductions with an updated signature so we can get to know each other better ??
Thanks -
Hi there,
I got same problem on my dm800, did resolver your problem?
Regards -
no ca error means your box has a certain bootloader version and that when you flashed your box with an image it had a different bootloader version . not hard to fix but avoidable , but the advice from the people here on this thread is good .
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!