No CA Found

Thanks to dreaoem toolbox I was able to revive mh DB dm800. After several attempts ans a lot of patience I manged to. Repai CA tool plus load image. I had to switch on and off severa time but I think worked only when I tried to switching on leeping on-off butto for a while after powering on, with stead dreambox logo on, after that I was able to operate dreamoptiflasher pro in advanced mode, IP and Serial, good job , I ma now going to setup, next challenge is activate TVSAT on scam 3.58 enjoy and thanks to you all

fy84tz Thanks for your imput ,perhaps you could pass by introductions now so we get to know each other ;)

I have same problem, no ca found in clone box.
After using optiflsher, I get dm800 detected . Wrong boot response.
Any one knows how fix it?

Use DreamUp 1.3.3 with serial (null modem) cable and flash your box with the correct image.

Quote from blackdevil

Use DreamUp 1.3.3 with serial (null modem) cable and flash your box with the correct image.

does not work

Open the receiver and check the SIM
Put it off and on so you can be sure that it is in the correct position.

Quote from blackdevil

Open the receiver and check the SIM
Put it off and on so you can be sure that it is in the correct position.

hello stranger ,
can you please pass by introductions with an updated signature so we can get to know each other better ??
Thanks

Hi there,
I got same problem on my dm800, did resolver your problem?
Regards

no ca error means your box has a certain bootloader version and that when you flashed your box with an image it had a different bootloader version . not hard to fix but avoidable , but the advice from the people here on this thread is good .