Hi
I accidently dropped my laptop while connected to the ET9000, and in trying to catch it sent something via DCC telnet, TV picture disappeared
immediately, dont know what went was sent via telnet.
The receiver now displays ET9X00 on display and will not respond to remote control or manual buttons, I have tried unplugging and re-flashing with various images, the receiver starts flash and then goes to booting but no further.
Any ideas on getting it running again would be appreciated.
thanks in advance
gmth63
Telnet mistake
- gmth63
- Thread is marked as Resolved.
There are 6 replies in this Thread which was already clicked 795 times. The last Post () by rami.
-
-
Quote
I have tried unplugging and re-flashing with various images, the receiver starts flash and then goes to booting but no further.
While trying to reflash a new image, did you update the bootloader so you can use the latest images ?
If you didn`t do this first the image won`t boot properly, download the latest et9000 bootloader, flash the same way you flash an image, then reflash the image again.
-
Hi thAnks for the reply
Yes tried reloading bootloader,but would not recognise it, it did already have the lastest bootloader before going wrong, I was using the latest VIX image.
I have also tried different usb sticks
thanks -
Are the usb sticks FAT32?
Also are you certain the backup battery didn't come loose?
-
reformat your usb stick in a windows pc/lappy before flashing ¬
-
Hi, thanks for reply,
yes usb sticks are formatted correctly, have reformatted again to be sure, havent moved the box, so battery shouldnt have come loose ,
tried reflashing again but with same result.
Is there any way of finding out what was telneted to the box?thanks
-
hi, the prob is when you download image to any reciever and stop by elitricity gon off in the midlell the dowload or the cable gon off rs 232 is big prob i think the only issue try to download with rs 232 or you have to go for jtag i dont no this reciever but i have somes bad experience in the past ,hope you get solution
-
master G
Moved the thread from forum Clarke-Tech | Xtrend Support to forum Xtrend - All Models. -
master G
Moved the thread from forum Xtrend - All Models to forum Xtrend ET-4000. -
master G
Moved the thread from forum Xtrend ET-4000 to forum Xtrend - All Models.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!