Dreambox 800 clone - No power

There are 2 replies in this Thread which was already clicked 1,684 times. The last Post () by todali.

    Firstly have you tried it with another plug



    Colleagues think that when you came to the breakout connector for voltage.
    Remove the cover from the receivers and see in the corner connector for power.
    Take the connector-to do when reciver not naponu.clean connector.
    Take a piece of wire reciver Plug-in power supply and contacts the legs where the connector and keeps going until the reciver does not work.
    Then quench reciver from power. go back connector back into place and turn on your normal reciver.
    Here's my dm 500hd before and turns to resolving my problem.


    If you have the same symptoms, then follow these steps and make sure you do not stick and do not touch anything except the contact on the blade where it goes konektor.Ili master carries you to the center


    All you're doing at your own risk

Firmware, downloads and support for Dreambox DM800 HD.

Your community resource for the Dreambox DM800 HD satellite receiver — firmware images, channel lists, plugins and setup help.