Motor and a Diseqc switch at same time??

There are 5 replies in this Thread which was already clicked 2,598 times. The last Post () by abu baniaz.

    i think the motor will work through port 1 of the diseqc switch However i'm not certain ?

    78cm dish on tm2300 metal gear motor + 1m Orb with tm2300 + 1.8m Channel Master on H-H floor mount + 80cm ISS with TM2300 AND Inverto Black LNB,inverto Unicable QUDL 42 LNB,- Global invacom Dscc LNB,- Triax KA LNB, - Yuri LNBF C Band YLF-CDP16C

    I assume you mean a Diseqc motor if so then yes it will work but you have to place the switch after the motor itself, so you would have a short Fly lead going from the LNB on the motorised dish into Input A and then from Fixed Dish into Input B then short fly lead from switch receiver output into Diseqc motor LNB input and job done.

    Do the set up like this


    Motorised



    Configuration Mode Advanced


    Satellite--------You need this setup for each sat position but not 7w. obviously enter you coordinates.
    LNB------------------------------LNB 1
    Priority-------------------------Auto
    LOF------------------------------Universal LNB
    Voltage mode---------------------Polarization
    Increased voltage----------------no
    Tone mode------------------------Band
    DiSEqC mode----------------------1.2
    Toneburst------------------------None
    Committed DiSEqC command---------AA
    Fast DiSEqC----------------------no
    Sequence repeat------------------no
    Command order--------------------committed,toneburst
    Uncommitted Diseqc Command-----None
    Diseqc Repeats-------------------None
    Longitude------------------------001.600
    ---------------------------------West
    Latitude-------------------------54.8
    ---------------------------------North
    Use Usals for this sat-------------Yes


    Fixed


    Configuration Mode Advanced


    Satellite--------7 west
    LNB------------------------------LNB 2
    Priority-------------------------Auto
    LOF------------------------------Universal LNB
    Voltage mode---------------------Polarization
    Increased voltage----------------no
    Tone mode------------------------Band
    DiSEqC mode----------------------1.0
    Toneburst------------------------None
    Committed DiSEqC command---------AB
    Fast DiSEqC----------------------no
    Sequence repeat------------------no
    Command order--------------------committed,toneburst


    Thanks to Ferret

General Satellite & Installation Support Forum

Support for LNBs, Single satellite, motorised and multi-satellite systems. DiSEqC switches, positioners, motors, actuators, dish-alignment help.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login