Motor and a Diseqc switch at same time??

There are 5 replies in this Thread which was already clicked 3,368 times. The last Post () by abu baniaz.

    i think the motor will work through port 1 of the diseqc switch However i'm not certain ?

    78cm dish on tm2300 metal gear motor + 1m Orb with tm2300 + 1.8m Channel Master on H-H floor mount + 80cm ISS with TM2300 AND Inverto Black LNB,inverto Unicable QUDL 42 LNB,- Global invacom Dscc LNB,- Triax KA LNB, - Yuri LNBF C Band YLF-CDP16C

    I assume you mean a Diseqc motor if so then yes it will work but you have to place the switch after the motor itself, so you would have a short Fly lead going from the LNB on the motorised dish into Input A and then from Fixed Dish into Input B then short fly lead from switch receiver output into Diseqc motor LNB input and job done.

    Do the set up like this


    Motorised



    Configuration Mode Advanced


    Satellite--------You need this setup for each sat position but not 7w. obviously enter you coordinates.
    LNB------------------------------LNB 1
    Priority-------------------------Auto
    LOF------------------------------Universal LNB
    Voltage mode---------------------Polarization
    Increased voltage----------------no
    Tone mode------------------------Band
    DiSEqC mode----------------------1.2
    Toneburst------------------------None
    Committed DiSEqC command---------AA
    Fast DiSEqC----------------------no
    Sequence repeat------------------no
    Command order--------------------committed,toneburst
    Uncommitted Diseqc Command-----None
    Diseqc Repeats-------------------None
    Longitude------------------------001.600
    ---------------------------------West
    Latitude-------------------------54.8
    ---------------------------------North
    Use Usals for this sat-------------Yes


    Fixed


    Configuration Mode Advanced


    Satellite--------7 west
    LNB------------------------------LNB 2
    Priority-------------------------Auto
    LOF------------------------------Universal LNB
    Voltage mode---------------------Polarization
    Increased voltage----------------no
    Tone mode------------------------Band
    DiSEqC mode----------------------1.0
    Toneburst------------------------None
    Committed DiSEqC command---------AB
    Fast DiSEqC----------------------no
    Sequence repeat------------------no
    Command order--------------------committed,toneburst


    Thanks to Ferret

Master your satellite setup with expert installation support.

Get dish alignment help, LNB guidance, and configuration tips for single, multi, and motorized systems. Your technical forum for satellite installation. Get support for LNBs, DiSEqC switches, motorized systems, actuators, and dish alignment for any setup.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login