Hello all and thanks in advance
i have been trying to flash this box with no success Below is what i have been trying
Installation OpenRSi image on Gigablue 800SE, 800UE and Quad.
We assume that you already installed the latest bootloader!
You need a USB flash drive that is formatted with Fat32.
Download the latest firmware from our download-section and unzip it in the root of the USB flash drive.
On your USB flash drive, it will look like \gigablue\se or \gigablue\ue.
Content of the folder should look like:
\gigablue\se\imageversion
\gigablue\se\kernel.bin
\gigablue\se\lcdsplash.bin
\gigablue\se\lcdwaitkey.bin
\gigablue\se\lcdwarning.bin
\gigablue\se\noforce
\gigablue\se\rootfs.bin
\gigablue\se\splash.bin
Turn/Power off you GigaBlue receiver.
Insert your USB flash drive. The USB port at the back of you receiver is preferred.
Turn/Power on your GigaBlue receiver.
The Standby-button on the receiver will color purple, and/or, the display will prompt you in yellow text.
In some cases, when turning on the GigaBlue, pressing the OK-button is necessary.
Confirm flashing with the OK button and the installation will begin.
ok when i download the se plus image from openrsi site and load to formatted fat32 stick i put on stick a folder named gigablue and in this folder this is the files from the image it starts gigablue then seplus then the files in this order
splash
rootfs
noforce
kernal
image
Is this correct as i cant seem to get box to see image to flash it also i have tried 3 sticks all same result box just boots up to openmips image which come on the box when new.