Single channel scan

Robin41 · May 28th 2014

Hi guys, I'm being a bit thick here but can anyone run me through the process of scanning for a specific channel.
Cheers.

**toothfairy** · May 28th 2014

Menu,setup,service searching,manual scan,predefined transponder,and down to transponder,
And right arrow to the frequency required and ok it.It will then scan the frequency.

**cazuela** · May 28th 2014

This is as close as I can find about adding transponder on an amiko,,,but not a single channel as you ask..

**toothfairy** · May 28th 2014

Ah I didn't enquirer what box he had,thanks cazuela for putting me right.

**cazuela** · May 28th 2014

Quote from toothfairy

Ah I didn't enquirer what box he had,thanks cazuela for putting me right.

I´m not sure either tooth bud,,its in the 8140 HD section, but I imagine most are similar,,just like other STBs..
so I would think your method would be of grteat help too ;)
But the vid is the only info I could find althjough its for a mini combo....
hopefully Robin41 will get back and let us know

Robin41 · Jun 26th 2014

Sorry for the late reply guy's, the channel I was after is actually no longer available in HD,I now have to access the channel in SD. Thanks for the reply's.

Single channel scan

Firmware, downloads and support for Amiko Models.

Share

Similar Threads

COMPLETE Set of Picons for American Satellites 40w - 135w

Zgemma h7 uhd 4k review

Zgemma H7 powervu help really needed

Automatic Scanning on BH 3.0.5

LinuxSat Community

Firmware Images

Receiver Support

Plugins & Tools

Resources