Have you checked the key are correct and could you be specific on the channels your talking about.
Posts by Compo
-
-
You need to install the softcam feed
-
Best option is to run a image with the correct patch if you can use OpenPLI or OpenATV those will correct the problem.
-
Vix have not released images with the patch to correct the narrator ac3 problem as yet OpenPLI and OpenATV have if you can use their images.
-
OpenPLI ,OpenATV and VTI have the correct drivers in their latest images to run powervu without steamrelay with this version of oscam.
-
2.9 on its own wont fix the narrator problems wait for the patched images to show.
OpenATV's latest images already have the patch if anyone is already running 6.1 then just do an online update.
-
There is no time bomb for the a8p sim you must use original images or you will get the no ca error
-
Images will be getting patched soon mate should see them from tomorrow better to wait for the proper patch rather than a dirty fix.
-
Display More
The patch by Athoik/Huevos has gone into OE Alliance 4.1 branch 4.1 last night. The submodule update was done this morning. You will have to wait until Sunday for images to include the modified libdvbsi++ file
The fix is for Virgin to broadcast using correct parameters.
Note:
OpenATV 5.0, Vix 5.0 and PLi 6.0 will not get the update
OpenATV 6.1 images are here
Codehttp://images.mynonpublic.com/openatv/6.1/Not the hakmax patch then ?
-
Did you have a version of ABM installed ?
If so you should leave that rename the folder to ABM 1 then ftp this in obviously chmod 755 the new abm folder
-
Any news on OpenATV? Still using Zgemma H1...
I,m not sure the OpenATV devs are even aware of the problem so you might be best asking over on their site.
There latest online update apparently includeds the ABM fix 2.9
-
2.9 is out although the github release from yesterday seem to be 2.8 still attached is 2.8
Anyone have 2.9 ?
-
Take the lid off look at the sim card and describe it.
-
hello,
can i ask, where can we find SSL#84 bootloader.? What are the steps to taken to flash a dreambox?
Clone or genuine box ?
-
Start by formating a usb drive on your computer.
In Notpad create a file called backupstick
Send this that to the root of your usb stick.
Insert the stick into the rear of your box and reboot.
Press the blue button on your remote
Select Software manager
Full Backup
Then Green Button to backup to usb -
Start by formating a usb drive on your computer.
In Notpad create a file called backupstick
Send this that to the root of your usb stick.
Insert the stick into the rear of your box and reboot.
Press the blue button on your remote
Select Software manager
Full Backup
Then Green Button to backup to usb -
by the way is possible to make a multiboot?
Never bothered with multiboot mate but running later versions of images in multiboot than the image in the flash is genrally a no no.
-
by the way is possible to make a multiboot?
Never bothered with multiboot mate but running later versions of images in multiboot than the image in the flash is genrally a no no.
-
The bin file is for use with DreamUP.
There really is no need for the extra step of flashing this bootloader though your already on a version of the 84 bootloader.
The no ca error only ever happens if you flash an image not intended for your sim type for example an original image on a clone
.
Youve been directed to images for your sim type so youll be fine.
-
Yes mate
