hi folks, the uno 4k se is playing up think its hardware as i've replaced remote control unit and reflashed it with different images but still not getting past a few steps in the setup after reflashing
only had it 15 months
problems started when the restart/shutdown menu would pop up ramdomly could only clear it by switching box off/on by the plug
decided to reflash the box, tried around 6 different images and each time the box would stop responding to the remote control as i was going though the setup screen,
so i got a new remote (hoping) that would sort it out by still stops as i'm going though the setup screen
tried the changing the RCU setting via the remote buttons OK & ON button, then 00002 ok lights on remote flash box flashes but still the box will not respond to the remote control
so think there must be some kind of hardware fault on the box,
using pure2 image it gets further along the setup than the other images
can't get the box to reload my old image ten below backup