not working with remote control

There are 6 replies in this Thread which was already clicked 1,587 times. The last Post () by jolinuxsat.

    hi folks, the uno 4k se is playing up think its hardware as i've replaced remote control unit and reflashed it with different images but still not getting past a few steps in the setup after reflashing


    only had it 15 months

    problems started when the restart/shutdown menu would pop up ramdomly could only clear it by switching box off/on by the plug

    decided to reflash the box, tried around 6 different images and each time the box would stop responding to the remote control as i was going though the setup screen,

    so i got a new remote (hoping) that would sort it out by still stops as i'm going though the setup screen

    tried the changing the RCU setting via the remote buttons OK & ON button, then 00002 ok lights on remote flash box flashes but still the box will not respond to the remote control


    so think there must be some kind of hardware fault on the box,

    using pure2 image it gets further along the setup than the other images

    can't get the box to reload my old image ten below backup

    this weekend tried a lot of images including VU+ origanal image some seem to be working well 20 mins even 1 hr but at some point either the box stops responding to the remote control or the restart/shutdown menu appears and you can't do anything other than switch the box off/on

    felt the temp of the box doesn't feel over hot

    Hello everyone, I'm returning to the topic since the same thing was happening to me with a VU+ UNO 4K SE Blackhole with a 5.4 image and the same problem. I removed the protective cover, which is three screws, and the problem was solved. I suppose it was an overheating issue. I'm posting in case it helps anyone. Thanks for this great forum.

    zeporro1000 read me in:

    Quote from jolinuxsat

    I should change title to thread because now it's happening independently from house temperature ,and now that have dismounted the pcb from front panel it's OK ,but if i try to remount it , the exit/reboot menu panel gets back to pop up.I'm sure is a problem related to touch sensor and some component that control it. It acts like someone is touching it long to pop up the exit/... menu. and then is hard to exit from it with remote ,keying exit or red key,sometime you are forced to switch off from rear.

    so it's needed a hardware expert among you.

    VU+UNO 4K SE running OpenAtv 7.6

VU+ UNO 4K SE PVR ready Linux Enigma2 Receiver UHD 2160p

Download VUPlus Images and Enigma2 Team Support from Black Hole, OpenATV, OpenBH, Open Black Hole, OpenDroid, OpenESi, OpenHDF, OpenLD, OpenPLi, OpenSPA, OpenViX, Open Vision, PKT Hyperion, PurE2, SatDreamGR, VTi.