sound level on PKT Hyperion image

go to menu - setup - system - a/v settings - ensure Audio Source is set to SPDIF and AC3/DTS downmix is set to no

audio is very low no matter what you do on most channels

work around turn tv up!

Quote from huester

anyone else having problems with the volume on this image. it is very low on many channels, and even when I increase TV volume it seems to have an upper limit which is not very high

Yes,the audio levels on channels with ac3 audio are very low.
The movie channels are the worst
This issue isnt confined to PKT though ,its the same on HDMU .
I try to use the mpeg audio stream where possible ,but that doesnt work well on the movie channels as the mpeg audio is usually for visually disabled .

PKT has channel control via the blue panel where you can specify the audio level on each channel individually,I think you can boost it by 30%.
You can also try the audio auto adjustment but that isnt great .

To be honest the audio levels inconsistency is the biggest flaw with the receiver as apart from that its really excellent.

I have this problem as well, it is happening on Open ARP , PKT, HDMU basically any enigma 2 image - I have tried both installing these images from scratch and installing people's preconfigured backups.

The movie channels are almost unwatchable the audio is that low.

I have been through all settings and cannot find anything to change it , I tried what musogeek suggested but when I change it to SPDIF and AC3/DTS downmix is set to no the sound then goes off. I did try rebooting my box after this as well.

Sound works ok if I boot to spark and I tried some image called Neutrino and it was ok on there as well.

I just loaded the Open PLi image and the audio is also bad on that, there used to be an autovolume plugin for dm500 and dm800 anyone tried it on this or is there something never?