Please advise how to fix the problem,'telnet not connected'Thanks in advance.
vu+ zero4k - Unable to connect with DCC
- jolatacqce
- Thread is marked as Resolved.
-
fix the above problem
There is nothing above your post to fix, so please rephrase your question.
-
password set ?
-
I use DCC 2.40 and you set a password in the VU and configurate DCC with the same password
-
Install IP Scanner, find the IP of your box,
Advanced IP Scanner – Téléchargez un analyseur de réseau gratuit
TS
-
-
-
You should say the image version you are using, makes it a lot easier to help. And what were you messing with passwords for?
Are you using windows on PC?
Say why you need to use DCC and you will get the solution.
-
You are not alone. DCC is very old, nearly older than ourselves, get WINSCP its for windows and easy to use just go slow. You will not regret it. When it opens you will get an option for the protocol, select FTP and then enter IP of box, then root then your password, you can save and it will login automatically thereafter, on the top left corner you will get the option for terminal and putty.
If stuck for any reason just post back.
ps I have the old age thing as well.
-
I followed the instructions re installing password,Pressed green button and saved it.Rebooted the receiver,TELNET still not connecting.
-
-
It should be on the left side, did you selected the "commander" like view ?
TS
-
As in the pic above if you look to top left and see the ip of your box just below is small box with an arrow click the arrow and it will show the file structure on your PC select the directory you want ie desktop, then depends yon where you have stored your plugins etc you just drag drop to the correct location on right hand side.
-
thank BM,i am now connected .Maybe by this time tomorrow Imight have made further progress.
-
Your support hub for the VU+ receiver.
Help, firmware and downloads for the VU+ Enigma2 satellite receiver. Ask about setup, channel lists, plugins and troubleshooting.
