hello
is it possible to have 2 diferent server listen ports in cccam cfg
thanks for help
el pirate:29_002:
There are 7 replies in this Thread which was already clicked 4,235 times. The last Post () by newtolinux.
-
-
i don't thinking it is possible to have 2 diferent server listen ports in cccam cfg...but i could be wrong!!
-
As far as I'm aware the answer is no. Is there any particular reason why you would like to do this? Maybe there's another work round you could do.
-
i have a strange problem with some clients to hook on my server.
the port i use normally is not 12000, i use 1 around 53xxx.
most clients are ok, but 2-3 have problems.
these clients are ok with port 12000 for example, so its a port issue i guess.
probably because ports over 49000 - 60000 seem to be "dynamic ports"???
apperantly this means this port stops after the job, and has to restart after every cw question (7 sec)why only some and not all my clients.
this has to do with internet provider transmitters, we have a special internet here in spain in my area.
anyway long story, but i would like to run this clients on another port in my cccam.now you tell me i cant have 2 server listen ports, i might do a routing in my router so they can use another port.
sorry is complicated
el pirate:sure: -
http://linuxsat-support.com/ca…-host-name-one-cccam.html
reading is the key to success ;)
maybe this isnt exactly the solution for your case ,but it would be the nearest thing ;)
salu2 caz -
Can be done, but require 2 instances of cccam to run.
-
maybe you should try with n lines, newcs, every card new port.... then maybe works
-
two instances of cccam are required with a special start command to point the 2nd instance at a different config directory . You would be far better just doing a port redirect in your router ; much simpler
new2
CCcam Support Forum
Configs, discussion, downloads and guides for CCcam Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!