i have dm 800hd s2 tuner and need to change to cable, Q is did it posible with ferrari sim . need anybody with experience to help.
Posts by herr flick
-
-
atributes???check!
-
i am using a laptop with ubuntu 12.04 lts.
I will try the advice from herr flick and will let you guys know.
Do you mean this?
address 192.168.1.87 (example)
broadcast 192.168.1.87yes try that maybe helps
-
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
-
try set address and broadcast same number
-
go to blue pannel and start cccam 1st
-
you no need ubuntu for few dm, just configure server on one of them and share to other.
-
why did you run cccam and oscam? just simple run oscam with setup cccam if you wish. every oscam runs also as cccam, just configure it in configuration. you haven`t any reason to run cccam alone.
-
set au = 0 to your client
and set au = 1 only on your spiderbox 7000hd
and give them cccammaxhop=1 -
m8 try chmod from 755 to 777 you know where, i contact you on ***pe afternoon
-
maybe it`s no reader oscam, try other oscam . and read carefully (when download) to avoid oscam no reader.
-
try with card mhz
set to 357 both, sometimes it will make lot throubles -
no need this, just like on printscreen above no cccam, there is oscam and cccam 2 in 1, just open port in router for cccam and that`s it oscam do everything including cccam now you need add users like in newcamd , infact you use oscam as cccam server all in one . and give cline like usual in cccam
ex:
account
user=someone
pwd= sometwo
group=1,2,3,4,.....
and create cline like:
C:yourdnsorip portincccam someone sometwo -
here you configure cccam in oscam, then restart oscam and that`s it m8
-
you will see when peer reshare your line because it`s too many more ecm reqests
-
yes, but you may share c line with oscam if you like, only go in configuration click cccam, define port and others parameters, reboot and after is everything like with newcamd (in oscam user)
-
you try to connect to cccam or server(ubuntu)
if you connect to cccam just tipe dyndns and open port for cccam tipe yourdns:port
if you try to connect to full acces to ubuntu then you must forward port 22 in router -
[newcamd]
port = whatewer you want @ caid : ident
key = 0102030405060708091011121314 (you may set other numbers)
keepalive = 1
that`s in conf
in user
user
[account]
user = what you want
pwd = whatyouwant
group = 1,2,3,........n line is
N:yourdns portinconf user pwd 0102030405060708091011121314 -
dual core is not in off for 64 bit, better you stay on 32 bit
-
try with that oscam if you are run 32bit linux:
